Chapter 19 Control Panel Setup (Panel)
959
Overall Control Panel Settings (Config Menu)
This applies to the preview selection buttons in the fade-to-black control block
and the downstream key/fade-to-black control block.
Notes
This operation cannot be done in the CCP-9000A.
1
In the Panel >Config menu, press [Link/Program Button].
The Link/Program Button menu appears.
2
Press [Fade To Black Module].
The Fade To Black Module menu appears.
On the left of the status area, preview selection buttons (1 to 11) appear.
On the right side a list of signals to be assigned appears.
3
In the button indications on the left, press the button for the assignment.
4
Using any of the following methods, select the signal to be assigned.
• Press directly on the list on the right.
• In the list on the right, press the arrow keys to scroll the reverse video
cursor.
• Turn the knob.
5
Press [Set].
This assigns the signal selected in the list to the button.
To cancel an assignment
Select the button, then press [Clear].
This leaves nothing assigned.
To return all preview selection button assignments to the factory
default state
In the Fade To Black Module menu, press [Default].
Knob Parameter Adjustment Setting values
1 Button Button selection 1 and upwards
To Next Page
Loading...
