Supermicro SSE-F3548S - Page 123

Supermicro SSE-F3548S/SSE-F3548SR Configuration User’s Guide
123
parameters for port channel interfaces.
Refer to the VLAN configuration guide
for all VLAN configuration details.
Step 6
Spanning Tree Configurations
Optional step – configures the spanning
tree parameters for port channel
interfaces.
Refer to the spanning Tree
configuration guide for all spanning
tree configuration details.
Step 7
End
Exits the configuration mode.
Step 8
show interface port-channel <channel-group-
Displays the configured port channel
number>
information.
show etherchannel [[channel-group-number] {
detail | load-balance | port | por
t-channel | summary | protocol}]
Step 9
write startup-config
Optional step – saves this port channel
configuration to be part of startup
configuration.
4.6.1.2 Adding Member Ports to Port Channels
Users can add up to eight member ports to static port channels. For LACP port channels, users can add
more than eight ports, but only the first eight member ports reaching a bundle state will be part of the
port channel for data transfer.