SYNAPTICON SOMANET Circulo 7 - Page 5

1.3.2.2.3 Interference with magnetic fields
1.3.2.3 On-site installation guide (UL)
1.3.2.3.1 Branch fuse required
1.3.2.3.2 Field wiring terminal marking
1.3.2.3.3 Downloads
1.3.3 LED signals
1.3.3.1 Overview
1.3.3.1.1 Legend
1.3.3.2 Core LED
1.3.3.2.1 Firmware
1.3.3.2.2 Bootloader
1.3.3.3 Drive LED
1.3.3.4 Com LED
1.3.4 SOMANET Node Safety (Original instructions)
1.3.4.1 Dimensions
1.3.4.2 Specifications of the safety functions
1.3.4.2.1 System requirements
1.3.4.2.2 Technical specifications
1.3.4.2.3 Block diagram
1.3.4.3 Setup of the safety functions
1.3.4.3.1 Connecting the STO/SBC inputs
1.3.4.3.1.1 STO/SBC input port
1.3.4.3.1.2 Wiring examples for the STO/SBC inputs
1.3.4.3.2 Connection diagram for the brake
1.3.4.3.2.1 Brake power output (STO/SBC)
1.3.4.3.3 Connector mating parts and cable lengths
1.3.4.4 Using the safety functions
1.3.4.4.1 Timing diagrams
1.3.4.4.1.1 Timing diagram for STO-function without connected brake
1.3.4.4.1.2 Timing diagram for STO-function with SBC-function
1.3.4.4.2 Truth table for digital inputs
1.3.4.4.3 Diagnostic functions
1.3.4.4.3.1 Fault diagnostics
1.3.4.4.3.2 Fault reaction
1.3.4.4.3.3 Resetting diagnostic faults
1.3.4.4.4 STO-SBC status register
1.3.4.5 Examples for realising safety functions
1.3.4.5.1 Prevention of unexpected start-up
1.3.4.5.2 Stop category 0 (STO)
1.3.4.5.3 Stop category 1 (SS1)
1.3.4.5.3.1 Prerequisites
1.3.4.5.3.2 Wiring
1.3.4.5.3.3 Configuration
1.3.4.5.3.4 Verification
1.3.4.6 Commissioning and maintenance
1.3.4.6.1 Commissioning
183
184
184
185
186
187
187
187
188
188
189
189
190
191
192
193
193
193
195
196
197
197
198
200
201
202
203
203
203
204
206
206
206
206
207
207
209
209
209
210
210
211
211
212
213
213
Synapticon Documentation
© 2021 Synapticon GmbH | Daimlerstraße 26 | D-71101 Schönaich Documentation v 4.19.0 | Built 2022-02-01 5/1031