To set details of optional device
201
Chapter 8
1
2
3
4
5
6
7
8
9
10
11
[e] Moving up of device at thread breakage
YES: To perform
NO: Not to perform
[f] Moving up of device when sequin chip runs out
YES: To perform
NO: Not to perform
[g] This setting prevents upper thread breakage by interference with device.
YES: To perform
NO: Not to perform
[h] Feed out sequin tip one by one by manual operation.(āp.203)
The feed amount is the value selected at [a] or [b] described above.
L: Left device
R: Right device
2-1-2. How to operate
The following is the example of setting in the conditions.below.
Feed amount of sequin chips of device (L1) at left side: 4.0
Insertion of jump data: To perform
Moving up of device at frame stepping: To perform
(1) To open screen
2 Sequin
NO
Sequin Up
YES/NO
Sequin Up at Sequin
YES/NO
YES
Jump Insertion
YES/NO
YES
(Y>0)
F3
[e]
[f]
[g]
Sequin chip
feed
[h]
at Thread Breakage
Tape Breakage
To Next Page
Loading...