Registration of a design into the machine memory
43
Chapter 4
1
2
3
4
5
6
7
8
9
10
11
(4) To read condition file
If the saving format of the selected design is T3 or T2, the following message will appear.
Condition file means Color Change Sequence and Design Start Position.
(5) To move frame to the design start position
After that, proceed to "To decide color change sequence (Needle Bar Selection)"(→p.53).
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
Pressing SET will move the frame, then data set will be
completed.
When the movement of the frame is not desired.
Data set is completed.
OK to read
condition data?
6(7
OK to move a
frame to the start
point of design
data ?
(
To Next Page
Loading...