TAJIMA TWMX-C - Page 95

To trim thread
81
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
[d] The number of return stitches at start of sewing
When "N" is displayed, the value differs in each needle bar.(→p.108)
The more return stitches are, the less mis-stitching at start decreases.
[e] Stitch length of [d] described above
When "N" is displayed, the value differs in each needle bar.(→p.108)
[f] Tie stitching at thread trimming
Setting more tie stitches prevent the thread from pulling out.
[g] Stitch length of [f] described above
When "N" is displayed, the value differs in each needle bar.(→p.108)
Triangle
1
2
3
T0:
One reciprocation
1 2
1:
Triangle + one
reciprocation
1
3
4 5
2
T1:
Two reciprocations
1 2
3 4
2:
Triangle + two
reciprocations
1
3
4 5
2
6 7
T2:
Without Return Stitches
Stitch at start of sewin
NO:
Not to perform tie stitching
Thread trimming position
A:
To perform tie stitching after lowering the
needle twice on the same position at the
end of the stitch
Thread trimming position
C:
To perform tie stitching (once)
Thread trimming position
B:
To perform tie stitching (twice)
Thread trimming position
D: