Technogym RUN NOW EXCITE + - 7.22.4. Disassembling the Running Deck and Belt

RUN NOW Excite +: Technical Service guide - rev. 6.2
Page 7.53
7.22.4. DISASSEMBLING THE RUNNING DECK AND BELT
In order to carry out these operations, it is necessary to slacken the tread-belt tension. If
the belt has to be used again, follow the instructions given in paragraph: 8.1.2.
“Tensioning a USED tread belt”.
Figure 7-19
Carry out the procedure described in paragraph:
7.14.1. “Disassembling the upper guard
” and
7.22.1. “Disassembling the footrest”.
1. Loosen the 2 screws (a) which fix the
stoppers to the frame of the machine,
using a
4mm hexagonal wrench.
7.22.4.1. A Typology
Figure 7-20
2. Back off the 2 screws (b) which fix the
running deck to the frame,
using a 6mm
hexagonal wrench.
3. Remove the running deck (c).
4. Remove the belt (d).
CAUTION: During the reassembly lock
down the screws using a torque wrench
set for 30Nm.
Figure 7-21
5. Remove the spacer (e).
During reassembly take care to correctly
insert the spa
cer (e) on the rear
supports
, as shown in the figure at the
side.
To reassemble the Running Deck and Belt, carry
out the above steps in reverse order.