Technogym RUN NOW EXCITE + - Enable Up-Down Motor; Format P&P

RUN NOW Excite +: Technical Service guide - rev. 6.2
Pagina 9.12
9.2.12. ENABLE UP-DOWN MOTOR
This parameter enables or disables use of the machine incline. To change the selection, when the
LED matrix shows the current setting:
UP-DOWN: xxx
Press the +/- GOAL keys to select the desired option out of those listed in the table below:
UP-DOWN
ENABLED <default>
DISABLED
9.2.13. ENABLE MULTI-LANGUAGE MODE
The machine can be configured to allow selection of the language at each session. To change the
selection, when the LED matrix shows the current setting:
LANGUAGE : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
LANGUAGE
FIXED <default>
OPTIONAL
9.2.14. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the LED matrix shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or preceding
parameter. If the ENTER key is pressed the LED matrix will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
9.2.15. FORMAT P&P
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
LED matrix shows:
FORMAT P&P
press ENTER to confirm. At the end of the format procedure, hold down the CLEAR key for a few
seconds to exit. The CLEAR key can be pressed at any time to interrupt the procedure and revert to
standby mode.