RUN NOW Excite +: Technical Service guide - rev. 6.2
Page 3.8
3.13. UNITY DEVICE
3.13.1. HEADPHONE AND MICROPHONE JACK
Earphones with microphone (For iPhone and/or Blackberry).
3.13.2. C-SAFE BOARD
This board provides a connector for communication between the outside world and compatible C-
Safe devices, for example: Cardio Theater players. This connector is located on the back of the
display.
This connector can be interfaced with an external PC to program the FLASH memory, using a
special cable.
3.13.3. NFC BOARD (PROXIMITY SENSOR)
The NFC board is located on the back of the keyboard for Minimal and U-TV, or on the back of the
front protection panel for UNITY, next to the related NFC / Wellness Cloud logo.
With this device it is possible to interface with smartphones equipped with NFC technology.
3.13.4. TV TUNER
This board receives and controls both digital and analogue Audio/Video signals arriving from the
aerial.
The aerial cable is connected directly to it, and the signal from the aerial is then amplified, divided
between the video and audio channels, coded by the decoder and processed by a tuner which makes
it possible to search for and tune into TV and Radio channels. The data are then sent to the Display
Board which processes them and controls them for correct viewing.
3.13.5. TGS READER
This device permits interaction of the equipment with the Wellness System.
It reads TGS and MyWellness Keys used by users to perform their workouts, by means of the
special Wellness System programmes.
The dual reader makes it possible to read both Botom and Mifare keys.
3.13.6. USB PORT
This is used for connection of USB devices for updates of: High Kit, Low Kit, TUNER board, TGS
reader and for transfer of network and RADIO and TV channel configurations from one interface to
another.
3.13.7. STAND-BY LED
This LED flashes when the equipment is started during the boot-up and whenever the LCD display
is switched of to reduce energy consumption.
When the LCD display is switched on, the LED is always switched off.
3.13.8. BACK-UP BATTERY
There is a battery on the Main Board which powers the internal clock when the equipment is not
connected to a power outlet.
To Next Page
Loading...
