Technogym RUN NOW EXCITE + - High Kit Version; BOOT Version; Mains Voltage

RUN NOW Excite +: Technical Service guide - rev. 6.2
Pagina 9.25
9.3.9. HIGH KIT VERSION
This function displays the SW version of the display. To do this, when the LED display shows:
HIGH KIT VERSION
press ENTER, the message that identifies the SW version, will appear.
9.3.10. BOOT VERSION
This function displays the BOOT version. To do this, when the display shows:
BOOT VERSION
press ENTER to display the message which identifies the BOOT version.
9.3.11. KEY READER VERSION
This function displays the SW version of the TGS reader. To do this, when the LED display shows:
KEY READER VERS.
press ENTER, the message that identifies the SW version, will appear.
9.3.12. MAINS VOLTAGE
This function allows the user to choose the proper power supply voltage for the machine. To change
the selection when the LED matrix shows the current setting:
MAINS VOLTAGE: XXX
Press the +/- GOAL keys to select the desired voltage setting from the options available. Press
ENTER to confirm the choice, use the + or – speed keys to move to the next or previous parameter.
The alternatives are:
Mains Voltage
NO SET
100Vac
120Vac
230Vac
Choosing “NO SET” value, when the machine is switched on it is necessary to insert the power
supply voltage provided by the electrical mains line.
Remember to properly set the parameter each time you replace the Display.