Technogym RUN NOW EXCITE + - Enable Custom Messages; Resetting Parameters to Default Values

RUN NOW Excite +: Technical Service guide - rev. 6.2
Pagina 9.6
9.1.14. ENABLE CUSTOM MESSAGES
It is possible to configure whether a custom message is displayed when the machine is in the
standby state. To change the selection, when the LED matrix shows the current setting:
CUSTOM MESS.: xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
CUSTOM MESS.
YES <default>
NO
9.1.15. ENABLE UP-DOWN MOTOR
This parameter enables or disables use of the machine incline. To change the selection, when the
LED matrix shows the current setting:
UP - DOWN: xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
UP - DOWN
ENABLED <default>
DISABLED
9.1.16. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the display shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – effort level keys to move to the next or
preceding parameter. If the ENTER key is pressed the display will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
9.1.17. FORMAT P&P KEY
This function formats a TGS key for Plug&Play mode operation. To select the function, when the
display shows:
FORMAT P&P
Press ENTER to confirm. At the end of the formatting procedure, hold down the CLEAR key for a
few seconds to exit. The CLEAR key can be pressed at any time to interrupt the procedure and
revert to standby mode.