Technogym RUN NOW EXCITE + - 8.4. Aligning the Tread-Belt Motor Drive-Belt

RUN NOW Excite +: Technical Service guide - rev. 6.2
Page 8.5
8.4. ALIGNING THE TREAD-BELT MOTOR DRIVE-BELT
Figure 8-3
Carry out the procedure described in paragraph:
7.14.1. “Disassembling the upper guard”.
1. Remove the dust guard.
2. Release the spring (a)
of the belt tensioning
mechanism.
3. Use a s
traight reference rod, resting it on the
pulley (b)
of the motor roller to align the belt
(c)
by shifting it within the races of the two
pulleys.
4. At the end, reassembly the tension spring (a).