Operating the Calculator 194
From the example above, the syntax for factor is:
Note: For details about the parameters, refer to that command’s description in the
Technical Reference module.
Viewing CATALOG Help
Viewing CATALOG HelpViewing CATALOG Help
Viewing CATALOG Help
You can display a command's parameters in a dialog box by pressing ƒ
Help. The
parameters are the same as those displayed on the status line.
Some commands, such as
ClrDraw, do not require parameters. If you select one of these
commands, parameters will not display on the status line and you will see Unavailable if
you press ƒ
Help.
Press N to exit the CATALOG Help dialog box.
factor(expression)
– or –
factor(expression,variable)
required
optional
Indicated
command and its
parameters.
To Next Page
Loading...
