Programming 573
Note: Arguments specify initial values for a program.
When you run a program, the TI-89 Titanium automatically checks for errors. For
example, the following message is displayed if you:
To cancel program execution if an error occurs, press N. You can then correct any
problems and run the program again.
Note: The TI-89 Titanium also checks for run-time errors that are found within the
program itself.
“Breaking” a Program
“Breaking” a Program “Breaking” a Program
“Breaking” a Program
When a program is running, the
BUSY indicator is displayed in the status line.
• Do not enter ( ) after the program name.
This error message appears if you:
• Do not enter enough arguments, if
required.
To Next Page
Loading...
