Texas Instruments Titanium TI-89 User Manual

Differential Equation Graphing 450
Fields=DIRFLD
Fields=DIRFLDFields=DIRFLD
Fields=DIRFLD
In the
Y= Editor
Enter a valid system of two 1st-order equations. For
information about defining a valid system for a 2nd-order
equation, refer to Example of a 2nd-Order Equation.
Set Axes = CUSTOM:
@2 ‰ If Axes = TIME, an Invalid axes error occurs
when you graph.
If you enter initial conditions in the Y= Editor, the equations
referenced by the custom axes must have the same number
of initial conditions.
Otherwise, a Dimension error occurs when you graph.
With custom
axes
Set axes that are valid for your system of equations.
Do not select t for either axis. Otherwise, an Invalid axes error
occurs when you graph.
The two axes must refer to different equations in your system
of equations. For example, y1 vs. y2 is valid, but y1 vs. y1'
gives an Invalid axes error.

Texas Instruments Titanium TI-89 Specifications

General

Display Type	LCD
Display Resolution	160 x 100 pixels
Memory	188 KB RAM, 2.7 MB Flash ROM
Type	Graphing Calculator
Display	Monochrome
Processor	Motorola 68000
Processor Speed	12 MHz
Power Source	4 AAA batteries
Connectivity	USB
Programming	TI-BASIC, Assembly
Operating System	AMS (Advanced Mathematics Software)