Texas Instruments Titanium TI-89 User Manual

Statistics and Data Plots 559
Showing the List of Stat Plots
Showing the List of Stat PlotsShowing the List of Stat Plots
Showing the List of Stat Plots
Press 8# to display the Y= Editor. Initially, the nine stat plots are located “off the top”
of the screen, above the
y(x) functions. However, the PLOTS indicator provides some
information.
To see the list of stat plots, use C to scroll
above the
y(x) functions.
From the Y= Editor, you can perform most of
the same operations on a stat plot as you can
on any other
y(x) function.
For example, PLOTS 23 means
that Plots 2 & 3 are selected.
If a Plot is highlighted, this shows
the data variable that will be used
for the plots.
If a Plot is defined, it shows the
same shorthand notation as the
Plot Setup screen.

Texas Instruments Titanium TI-89 Specifications

General

Display Type	LCD
Display Resolution	160 x 100 pixels
Memory	188 KB RAM, 2.7 MB Flash ROM
Type	Graphing Calculator
Display	Monochrome
Processor	Motorola 68000
Processor Speed	12 MHz
Power Source	4 AAA batteries
Connectivity	USB
Programming	TI-BASIC, Assembly
Operating System	AMS (Advanced Mathematics Software)