Texas Instruments Titanium TI-89 User Manual

Basic Function Graphing 302
Basic Function Graphing
Basic Function GraphingBasic Function Graphing
Basic Function Graphing
Overview of Steps in Graphing Functions
Overview of Steps in Graphing FunctionsOverview of Steps in Graphing Functions
Overview of Steps in Graphing Functions
To graph one or more y(x) functions, use the general steps shown below. For a detailed
description of each step, refer to the following pages. You may not need to do all the
steps each time you graph a function.
Graphing Functions
Graphing FunctionsGraphing Functions
Graphing Functions
1. Set
Graph mode (3) to FUNCTION.
Also set
Angle mode, if necessary.
2. Define x and y components on Y= Editor
(8#).
3. Select (†) which defined functions to
graph.
Note: To turn off any stat data plots, press
‡
5 or use † to deselect them.

Texas Instruments Titanium TI-89 Specifications

General

Display Type	LCD
Display Resolution	160 x 100 pixels
Memory	188 KB RAM, 2.7 MB Flash ROM
Type	Graphing Calculator
Display	Monochrome
Processor	Motorola 68000
Processor Speed	12 MHz
Power Source	4 AAA batteries
Connectivity	USB
Programming	TI-BASIC, Assembly
Operating System	AMS (Advanced Mathematics Software)