Programming 575
Note: To clear any previous output, enter the Clr[O command in your program. You can
also execute
Clr[O from the Home screen.
When a program stops on the Program I/O screen, you need to recognize that it is not
the Home screen (although the two screens are similar). The Program I/O screen is
used only to display output or to prompt the user for input. You cannot perform
calculations on this screen.
Note: If Home screen calculations don’t work after you run a program, you may be on the
Program I/O screen.
Leaving the Program I/O Screen
Leaving the Program I/O ScreenLeaving the Program I/O Screen
Leaving the Program I/O Screen
From the Program I/O screen:
• Press ‡ to toggle between the Home screen and the Program I/O screen.
– or –
• Press N, 2 K, or
@ "
"to display the Home screen.
– or –
• Display any other application screen (with O, 8#, etc.).
Last output
On the Program I/O screen:
‡ toolbar is available; all
others are dimmed.
There is no entry line.
To Next Page
Loading...
Need help?
General
