Maintenance and Troubleshooting
On-Screen Warnings
4-22 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
If an optional printed-circuit board assembly is installed or removed on
power up, the Micro-Tech will recognize the change and request a
reconfigure. This message is only available for a limited time. If the
Micro-Tech is not reconfigured, the option installed will not function.
The “No Speed Pulses” warning can occur during a number of
procedures, as described below.
While Doing a Zero or Span Calibration
Acquire new
Configuration?
Calibration aborted
To Next Page
Loading...
