Initializing the Micro-Tech
Initializing the Software
2-24 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
1. Feet is the default value.
2. As no other choices are available, press the down-arrow button to
bring up the rate units screen (go to page 2-23).
The Micro-Tech display should currently look like this, if you chose
metric units.
1. Meters is the default value.
2. As no other choices are available, press the down-arrow button to
bring up the rate units screen (see the next section).
Length Units
> meters <
To Next Page
Loading...
