Thermo Scientific Micro-Tech 9101 - Initializing the Software

Initializing the Micro-Tech
Using the Console
Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J 2-13
the result, “Number of revolutions for test,” in Table 2–1 or Table
2–2.
6. Multiply “Number of revolutions for test” by the time taken (in
seconds) for one revolution. Enter the result, “Time to complete test
revolutions,” in Table 2–1 or Table 2–2.
You are now going to familiarize yourself with the Micro-Tech’s
console, and use it to enter into the Micro-Tech all the data you entered
in Table 2–1 or Table 2–2.
Please see page 3-1 of the manual to familiarize yourself with the Micro-
Tech’s console and how to use it.
This section gives you step-by-step instructions to guide you through the
software-initialization process.
NOTE. You must complete the entire software initialization and scale-
calibration procedure before putting the Micro-Tech into operation.
There are no shortcuts! 
There are five steps in the software initialization process, as follows.
 Enter the correct date and exact current time.
 Choose the appropriate language for the display.
The Next Steps
Using the
Console
Initializing the
Software
Overview