Thermo Scientific Micro-Tech 9101 - Span Calibration Menu

Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J B-13
Here is the Span Calibration menu table.
Parameter
Selection
Description
AUTO SPAN
START, EXIT, MANUAL
R Cal
Run belt empty, then press START
AUTO SPANNING ABORT
Time remaining
Rate
Tot
AUTOSPAN COMPLETE
YES, NO, ADV
XXXX = Error, Total,
Calcon, Mat’l fact*
*Only present when a
Material Factor is installed
for the current simulated
load method.
XXXX
Change Span?
SPAN # CHANGED RUN, REPEAT, ADV
XXXX = Old span #, Error,
Total, Calcon, Mat’l fact*
*Only present when a
Material Factor is installed
for the current simulated
load method.
XXXX
New span #
SPAN UNCHANGED
RUN, REPEAT, ADV
XXXX = Old span #, Error,
Total, Calcon, Mat’l fact*
*Only present when a
Material Factor is installed
for the current simulated
load method.
XXXX
New span #
AUTO SPAN Chain
START, EXIT, MANUAL
Press Start to begin Chain calibration
AUTO SPAN Chain
START, EXIT
Apply chain then press START
AUTO SPAN Chain
START, EXIT
Run belt, then press START
Remove Chains before returning to
normal operation!
RUN, MENU
AUTO SPAN Weights
START, EXIT, MANUAL
Span Calibration
Menu