Thermo Scientific Micro-Tech 9101 - Diagnostics Menu

Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J B-33
Here is the Diagnostic menu table.
No.
Parameter
Selection
Description
1 A/D gross 1
A/D gross 2*
A/D gross 3**
A/D gross 4**
A/D net
0 - 131070 Digital representation of gross load at the
load cell.
*Available only when Type of scale set to
Two A/D Channel.
**Available only when Type of scale set to
Four A/D Channel.
Digital representation of “material” load at the
load cell. (gross – zero No.)
2
Weight on load cell
#1-J16____mV
#2-J21____mV
1
#3-J1_____mV
2
#4-J2_____mV
2
#J9_____mV
3
Gross load at load cell. Presented in mvdc
format.
Note: After A/D conversion.
1
Available only when Type of scale set to
Two A/D Channel.
2
Available only when Type of scale set to
Four A/D Channel.
3
Model 9201.
2A
Loadcell output zero
15 A/D counts (0 -
10000)
Fine adjust of load cell mv/v zero set. Factory
adjusted. Not to be changed in the field
2B
Loadcell output span
(0 - 30000)
Fine adjust of load cell mv/v span set.
Factory adjusted. Not to be changed in the
field
3
Prescale___
#1_____ pls/min
1 (0 - 100)
A divider to bring the speed pulses to within
a range of 1500-2500 pulses per minute.
Incoming speed pulses (after prescale) per
minute
3A
Test duration total
pulses
(1 - 1,000,000)
Total number of speed pulses during a test
duration (calibration time). Not applicable for
simulated speed.
3B
Test duration total
length
(1 - 100,000 ft)
Test duration total belt length. Not applicable
for simulated speed.
4
Enter SERVICE
password
Enter Service password to enable protection.
Up to eight characters long.
It is strongly recommended you write down
the password and keep a copy in a safe
place.
To remove a password, just press EDIT and
then ENTER. (Password: Service.)
5
Enter OPERATOR
password
Enter Operator password to enable
protection.
Up to eight characters long.
It is strongly recommended you write down
Diagnostics
Menu