Initializing the Micro-Tech
Initializing the Software
2-18 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
10. The time is now set. Press the down-arrow button to bring up the
USB screen. The Micro-Tech pauses for about 10 seconds, while it
checks for the presence of a flash drive in the USB port. (If you
were rebooting the Micro-Tech to restore your previously saved
settings, this is where you would insert the back-up flash drive into
the USB port.)
11. After waiting briefly, press the down-arrow button to bring up the
language screen.
The default language shown in the Micro-Tech display is English. You
can, however, choose other languages.
1. The Micro-Tech display should currently look like this.
BATCH
Choose the language
key to continue to
> ENGLISH <
READY ALARM CALIB
ENTER CHOICE
CLEAR
Check USB present
To Next Page
Loading...
