Operation
Running the Micro-Tech
3-4 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
The Micro-Tech continuously monitors your scale and continuously
updates the figures for total tons (Tons) and tons per hour (Tph). So,
after operating the scale for a while, the display should look something
like this. (Your totals will be different, and your units of measurement
may be different, because, for example, you chose metric units when
setting up the Micro-Tech.)
There are three totals, as follows.
Master Total
This works like the odometer on a vehicle, and records the total
amount of weight that has crossed the scale since the Micro-Tech
was first put into operation. And, like a vehicle’s odometer, it can be
used to decide when scheduled maintenance is due on the conveyor
and/or scale. The Master total can only be reset by the system
administrator at your facility, or by a Thermo Fisher Scientific
service technician.
Reset Total
This total can be reset.
Operator Total
This is a second resettable total and records the total for an
individual operator, if you have set up this feature.
12.7 Tons
1.4 Tph
To Next Page
Loading...
