Thermo Scientific Micro-Tech 9101 - Partial Belt-Length Method

Thermo Fisher Scientific Micro-Tech 9101/9201 Reference Manual, Rev J A-9
The partial belt-length method should only be used if the belt is longer
than 1,000 feet.
Pressing the Abort button at anytime returns you to the “Cal Data
Scroll 12” screen shown below.
To use the partial belt-length method, do the following.
1. Press the Acquire button and the following screen appears.
2. Mark and measure a section of the belt. The section you mark must
be longer than 200 feet.
Partial Belt-
Length Method
BATCH
- CAL DATA SCROLL 12 -
Establish test
duration
READY
ALARM
CALIB
MANUAL
ACQ
BATCH
ACQUIRE TEST DUR
Choose belt length
measuring method
READY
ALARM
CALIB
PARTIAL
FULL