Introduction
Hardware Installation
1-8 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
operator and must be marked as the disconnecting device for the
Micro-Tech and associated equipment.
All conduits should enter the bottom of the enclosure. Do not run
conduit through the top or sides of the enclosure.
The Micro-Tech should be mounted in a controlled environment and
protected (shielded) from direct sunlight, and should not be exposed to
excessive vibration, heat, or moisture. It may be mounted up to 3,000 ft
(914 m) from the scale. The figure below shows a typical installation.
Figure 1–3. A Typical 9101 Field-Mounted Installation
Installing the
Field Model
To Next Page
Loading...
