Thermo Scientific Micro-Tech 9101 - Page 222

B-50 Micro-Tech 9101/9201 Reference Manual, Rev J Thermo Fisher Scientific
No.
Parameter
Selection
Description
3B High speed set
___ ___
100% (0 - 150%)
10 sec (0 - 90 sec)
600 FPM (0 - 900 FPM)
Alarm Number
Alarm
Number
Description
Selection
Description
#1
Clock Fail
ALARM, SHUT DOWN, AUTO
RES., NONE
The system has detected a
failure on the clock calendar
circuit. Go to the Diagnostics
menu and re-enter the date
and time. Check the battery.
Replace the motherboard.
#3
Signal cell fail S1
ALARM, SHUT DOWN, AUTO
RES., NONE
#4
Signal cell fail S2
ALARM, SHUT DOWN, AUTO
RES., NONE
#7
RAM fail
ALARM, SHUT DOWN, AUTO
RES., NONE
The system has detected an
error on the RAM (Random
Access Memory) checksum
during the internal periodic
test. The RAM is used to
store variables and set up
data.
Replace the motherboard.
#8 ROM fail ALARM, SHUT DOWN, AUTO
RES., NONE
The system has detected an
error on the ROM (Read Only
Memory) checksum during
the internal periodic test. The
ROM is used to store the
program.
Replace the motherboard.
#10
High load
ALARM, SHUT DOWN, AUTO
RES., NONE
Only present when Load
alarm is set to Yes.
#13
Low load
ALARM, SHUT DOWN, AUTO
RES., NONE
Only present when Load
alarm is set to Yes.
#16
High rate
ALARM, SHUT DOWN, AUTO
RES., NONE
Only present when Rate
alarm is set to Yes.
#19 Low rate ALARM, SHUT DOWN, AUTO
RES., NONE
Only present when Rate
alarm is set to Yes.
#22
High speed
ALARM, SHUT DOWN, AUTO
RES., NONE
Only present when Speed
alarm is set to Yes.
#25
Low speed
ALARM, SHUT DOWN, AUTO
RES., NONE
Only present when Speed
alarm is set to Yes.