of OSHA in respect to the equipment supplied or for any penalty assessed for failure to meet the requirements,
in respect to the equipment supplied, as interpreted by an authorized inspector. Thermo Fisher Scientific will
use their best efforts to remedy such violation at a reasonable cost to the buyer.
Important Safety Notices about Using the Micro-Tech
Please note carefully the following safety warnings and notices.
Safety in Transportation and Handling
The Micro-Tech is an integral part of your plant and when transporting, handling, and installing the unit, your
own plant safety instructions must be applied. Because your Micro-Tech and associated systems are tailored
to application requirements, it is impossible to be precise about product mass/weight. If precise values are
required, the shipping crate will be marked with the overall shipping mass of the product and this may be used
as a reasonable guideline.
Safe Practices During Use, Maintenance, and Repair
This manual contains details, as appropriate, including the appropriate tools. However, because of its
importance, the warning contained in the installation section is repeated here.
TO GUARANTEE PERSONAL SAFETY, CARE MUST BE TAKEN WHEN WORKING ON OR
AROUND THE MICRO-TECH. AS WITH ALL SUCH DEVICES THE MAIN SUPPLIES (ELECTRICAL
AND OTHER) TO THE SYSTEM MUST BE LOCKED OFF WHEN PERFORMING REPAIR OR
MAINTENANCE WORK. AFTER DISCONNECTING, SWITCH OFF AND LOCK THE ELECTRICAL
SUPPLY.
Training Needs of Users
We offer all customers full training for operations and maintenance staff.
Low Voltage Directives
All of the recommendations for LVD apply to the prevention of electrical shock. If access to the electronics
enclosure is required, the incoming AC power supply should be isolated remotely and locked-off. Access to
the electronics enclosure by untrained personnel is not recommended.
Circuit Breaker
The Micro-Tech should be permanently connected to its AC supply. Please ensure that when installing the
Micro-Tech, a switch or circuit breaker is used and is positioned close to the Micro-Tech in easy reach of the
operator. The switch or circuit breaker shall be marked as the disconnecting device for the Micro-Tech.
DO NOT install the Micro-Tech in a position that makes it hard to use the AC mains isolator.
Thermo Fisher Scientific Warranty
The seller agrees, represents, and warrants that the equipment delivered hereunder shall be free from defects
in material and workmanship. Such warranty shall not apply to accessories, parts, or material purchased by the
To Next Page
Loading...
