TP-Link Jetstream TL-SL2428P - Page 122

Managing Physical Interfaces Port Isolation Configurations
User Guide 99
Step 3 port isolation { [fa-forward-list fa-forward-list ] [gi-forward-list gi-forward-list ] [te-
forward-list te-forward-list ] [ po-forward-list po-forward-list ] }
Add ports or LAGs to the forwarding port list of the isolated port. It is multi-optional.
fa-forward-list / gi-forward-list / te-forward-list : Specify the forwarding Ethernet ports.
po-forward-list: Specify the forwarding LAGs.
Step 4 show port isolation interface { fastEthernet port | gigabitEthernet port | ten-
gigabitEthernet port | port-channel port-channel }
Verify the Port Isolation configuration of the specified port.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to add ports 1/0/1-3 and LAG 4 to the forwarding list of
port 1/0/5:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/5
Switch(config-if)#port isolation gi-forward-list 1/0/1-3 po-forward-list 4
Switch(config-if)#show port isolation interface gigabitEthernet 1/0/5
Port LAG Forward-List
---- --- -----------------------
Gi1/0/5 N/A Gi1/0/1-3,Po4
Switch(config-if)#end
Switch#copy running-config startup-config
Downloaded from ManualsNet.com search engine