Configuring GVRP Configuration Example
User Guide 207
Switch_1(config)#interface gigabitEthernet 1/0/1
Switch_1(config-if)#switchport general allowed vlan 10 tagged
Switch_1(config-if)#gvrp
Switch_1(config-if)#gvrp registration fixed
Switch_1(config-if)#end
Switch_1#copy running-config startup-config
■ Configurations for Switch 2
1) Enable GVRP globally.
Switch_2#configure
Switch_2(config)#gvrp
2) Create VLAN 20.
Switch_2(config)#vlan 20
Switch_2(config-vlan)#name Department_B
Switch_2(config-vlan)#exit
3) Add tagged port 1/0/1 to VLAN 20. Enable GVRP on the port and set the registration
mode as Fixed.
Switch_2(config)#interface gigabitEthernet 1/0/1
Switch_2(config-if)#switchport general allowed vlan 20 tagged
Switch_2(config-if)#gvrp
Switch_2(config-if)#gvrp registration fixed
Switch_2(config-if)#end
Switch_2#copy running-config startup-config
■ Configurations for Switch 5
1) Enable GVRP globally.
Switch_5#configure
Switch_5(config)#gvrp
2) Enable GVRP on ports 1/0/1-3.
Switch_5(config)#interface range gigabitEthernet 1/0/1-3
Switch_5(config-if-range)#gvrp
Switch_5(config-if-range)#end
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
