User Guide 388
Configuring LLDP Configuration Example
Switch_A(config)#lldp
Switch_A(config)#lldp hold-multiplier 4
Switch_A(config)#lldp timer tx-interval 30
Switch_A(config)#lldp timer tx-delay 2
Switch_A(config)#lldp timer reinit-delay 3
Switch_A(config)#lldp timer notify-interval 5
Switch_A(config)#lldp timer fast-count 3
2) Set the Admin Status of port Fa1/0/1 to Tx&Rx, enable Notification Mode and configure
all the TLVs included in the outgoing LLDP packets.
Switch_A#configure
Switch_A(config)#interface fastEthernet 1/0/1
Switch_A(config-if)#lldp receive
Switch_A(config-if)#lldp transmit
Switch_A(config-if)#lldp snmp-trap
Switch_A(config-if)#lldp tlv-select all
Switch_A(config-if)#end
Switch_A#copy running-config startup-config
Verify the Configurations
View LLDP settings globally
Switch_A#show lldp
LLDP Status: Enabled
LLDP Forward Message: Disabled
Tx Interval: 30 seconds
TTL Multiplier: 4
Tx Delay: 2 seconds
Initialization Delay: 2 seconds
Trap Notification Interval: 5 seconds
Fast-packet Count: 3
LLDP-MED Fast Start Repeat Count: 4
View LLDP settings on each port
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
