Configuring Access Security Access Security Configurations
User Guide 507
2) In the Entry Config section, click to add an Access Control entry.
■ When the IP-based mode is selected, the following window will pop up.
Figure 2-2 Configuring Access Control Based on IP Range
Access
Interface
Select the interfaces where to apply the Access Control rule. If an interface is
unselected, all users can access the switch via it.
SNMP: A function to manage the network devices via NMS.
Telnet: A connection type for users to remote login.
SSH: A connection type based on SSH protocol.
HTTP: A connection type based on HTTP protocol.
HTTPS: A connection type based on SSL protocol.
Ping: A communication protocol to test the connection of the network.
IP Address/
Mask
Enter the IP address and mask to specify an IP range. Only the users within this IP
range can access the switch via the specified interfaces.
■ When the MAC-based mode is selected, the following window will pop up.
Figure 2-3 Configuring Access Control Based on MAC Address
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
