TP-Link Jetstream TL-SL2428P - Page 58

Managing System System Info Configurations
User Guide 35
Step 2 hostname [ hostname ]
Specify the system name of the switch.
hostname : Enter the device name. The length of the name ranges from 1 to 32 characters. By
default, it is the model name of the switch.
Step 3 location [ location ]
Specify the system location of the switch.
location : Enter the device location. It should consist of no more than 32 characters. By default,
it is “SHENZHEN”.
Step 4 contact-info [ contact-info ]
Specify the system contact Information.
contact-info : Enter the contact information. It should consist of no more than 32 characters.
By default, it is “www.tp-link.com”.
Step 5 show system-info
Verify the system information including system Description, Device Name, Device Location,
System Contact, Hardware Version, Firmware Version, System Time, Run Time and so on.
Step 6 end
Return to privileged EXEC mode.
Step 7 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to set the device name as Switch_A, set the location as
BEIJING and set the contact information as https://www.tp-link.com.
Switch#configure
Switch(config)#hostname Switch_A
Switch(config)#location BEIJING
Switch(config)#contact-info https://www.tp-link.com
Switch(config)#show system-info
System Description - JetStream 24-Port Gigabit L2 Managed Switch with 4 SFP Slots
System Name - Switch_A
System Location - BEIJING
Contact Information - https://www.tp-link.com
...
Switch(config)#end
Switch#copy running-config startup-config
Downloaded from ManualsNet.com search engine