TP-Link Jetstream TL-SL2428P - Page 598

User Guide 575
Configuring 802.1x Configuration Example
Switch_A(config)#interface fastEthernet 1/0/3
Switch_A(config-if)#no dot1x
Switch_A(config-if)#exit
Switch_A(config)#interface fastEthernet 1/0/1
Switch_A(config-if)#dot1x
Switch_A(config-if)#dot1x port-method mac-based
Switch_A(config-if)#dot1x port-control auto
Switch_A(config-if)#exit
Verify the Configurations
Verify the global configurations of 802.1x authentication:
Switch_A#show dot1x global
802.1X State: Enabled
Authentication Protocol: EAP
Handshake State: Enabled
802.1X Accounting State: Disabled
802.1X VLAN Assignment State: Disabled
Verify the configurations of 802.1x authentication on the port:
Switch_A#show dot1x interface
Port State MAB State GuestVLAN PortControl PortMethod
---- ----- --------- --------- ----------- ----------
Fa1/0/1 enabled disabled 0 auto mac-based
Fa1/0/2 disabled disabled 0 auto mac-based
Fa1/0/3 disabled disabled 0 auto mac-based
...
MaxReq QuietPeriod SuppTimeout Authorized LAG
------ ----------- ----------- ---------- ---
3 10 30 unauthorized N/A
3 10 30 unauthorized N/A
Downloaded from ManualsNet.com search engine