TP-Link Jetstream TL-SL2428P - Page 706

User Guide 683
Configuring IPv6 IMPB IPv6 Source Guard Configuration
Step 4 show ipv6 verify source [ interface { fastEthernet port | gigabitEthernet port | ten-
gigabitEthernet port | port-channel port-channel-id } ]
Verify the IP Source Guard configuration for IPv6 packets.
Step 5 end
Return to privileged EXEC mode.
Step 6 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to enable IPv6 Source Guard on port 1/0/1:
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#ipv6 verify source sipv6+mac
Switch(config-if)#show ipv6 verify source interface gigabitEthernet 1/0/1
Port Security-Type LAG
---- ------------- ----
Gi1/0/1 SIPv6+MAC N/A
Switch(config-if)#end
Switch#copy running-config startup-config
Downloaded from ManualsNet.com search engine