TP-Link Jetstream TL-SL2428P - Page 774

Configuring DLDP DLDP Configuration
User Guide 751
Switch(config)#dldp
Switch(config)#dldp interval 10
Switch(config)#dldp shut-mode auto
Switch(config)#show dldp
DLDP Global State: Enable
DLDP Message Interval: 10
DLDP Shut Mode: Auto
Switch(config)#end
Switch#copy running-config startup-config
The following example shows how to enable DLDP on port 1/0/1.
Switch#configure
Switch(config)#interface gigabitEthernet 1/0/1
Switch(config-if)#dldp
Switch(config-if)#show dldp interface
Port DLDP State Protocol State Link State Neighbor State
---- ---------- -------------- ---------- --------------
Gi1/0/1 Enable Inactive Link-Down N/A
Gi1/0/2 Disable Initial Link-Down N/A
...
Switch(config-if)#end
Switch#copy running-config startup-config
Downloaded from ManualsNet.com search engine