Trango Systems TrangoLINK GigaPlus - Enable Adaptive Coding and Modulation (ACM) (Optional)

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 119
In some cases the Freq duplex can be changed, but typically this will not be necessary.
Changing the Freq duplex will automatically change the RX frequency. The opmode
must be off to set the frequency.
First set the local end transmit frequency:
(CLI-config)# freq 22300
Tx Freq: 22300.00 (MHz)
Rx Freq: 23500.00 (MHz)
Freq Duplex: 1200.00 (MHz)
Next, Set the far end transmitter frequency (separate session with the other radio)
(CLI-config)# freq 23500
Tx Freq: 23500.00 (MHz)
Rx Freq: 22300.00 (MHz)
Freq Duplex: 1200.00 (MHz)
If the system has been installed and the far end transmitter is also on the link can be
checked using the linktest command
(CLI-config)# linktest
LOCK RSSI MSE BER
1> 1 -45.00 -36.70 0.00E+00
Step 5: Enable Adaptive Coding and Modulation (ACM) (Optional)
If ACM is desired, the acm enable command should be used on both ends of the link.
IMPORTANT: After the ACM is enabled after initial link establishment, the speed
command must be reissued.
(CLI-config)# acm enable on
ACM enable: on
SUCCESS