Trango Systems TrangoLINK GigaPlus - Utype

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 201
EXAMPLE
To display current uptime
(trango-config)# uptime
20:45:58 up 1:49, load average
RELATED
Date
utype
SYNTAX
utype
Default: N/A
Configuration Storage: N/A
utype without any parameter will display current utype and other
related status.
DESCRIPTION
Utype command will display unit’s current utype, remote unit status,
election period status and sync status.
Current utype: No utype, Active, or Standby
Protection: Indicated if HW swiching protection is ON/OFF, dependent
upon the standby link status and guard time protection.
Remote unit status: no detection, Standby detected, active detected
Sync Status: Current configuration synchronization status.
Synchronized or Not synchronized.
Guard Time: Currently user configured guard interval.