Trango Systems, Inc. GigaPlus User Manual Rev 3.1 54
Command Line Interface (CLI) using SSH, Telnet or Console
All typical radio functions can be managed via the browser interface, but the Command
Line Interface (CLI) has additional functionality that facilitates installation and
troubleshooting.
The Command Line Interface has 3 nodes: View, Config, and Debug. Logging into the
radio via Command Line Interface is covered here briefly, and a complete listing of all
CLI commands is provided in Appendix A
Logging into the radio via Command Line Interface is covered here briefly. A complete
listing of all CLI commands is provided in Appendix A - Command Line Interface.
Launch Telnet
Open a command prompt (DOS) session on your PC (Windows® Start icon and select
“Run”). Open a Telnet session by typing:
telnet [ip address of radio]
Example:
C:>telnet 192.168.100.100
Once at the CLI login prompt, type in the login and press enter, then the password and
press enter.
CLI login: admin
Password: (No characters will be display during input)
Trango System: TrangoLINK GigaPlus Command Line Interface
v1.0.0
(CLI-view)#
If the incorrect password is entered during login, the system will allow two more tries
before terminating a telnet session. A new session will need to be open to try again.
To terminate a CLI session (Telnet or Console) simply close the console window. A CLI
SESSION CAN ALSO BE TERMINATED FROM THE DEBUG NODE WITH “EXIT” COMMAND.
View Node : (CLI-view)# prompt allows view level only, and no parameters of the
radio link can be changed.
To Next Page
Loading...