Trango Systems TrangoLINK GigaPlus - Debug Node Command List

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 145
Debug Node
This node is additional management port related settings and users enter the debug
node, by typing in the debug command from the config node. Users can re-enter the
view node by entering the cli command from within the debug node.
Debug Node Command List
cli
N/A
Used to Enter the CLI (trango-view) node
exit
N/A
Exit out of the session (clean exit)
help
N/A
Display list of commands in the debug node
ping
<ip address>
ping network hosts
passwd
<passeword>
Reset the main password into view node
route
N/A
Display the current system routing table
ssh
<ip address>
ssh into another host
syslog
N/A
print system log
telnet
<ip address>
telnet into another host
uptime
N/A
Display the current uptime and system load
tg_reboot
N/A
Reboot radio