Update to reflect the following feature changes in SW V3.0 plus bug
fixes (see release note for bug fixes)
- Allow IBM without a VLAN
- Custom Speed Profile Support
- Support for 5. 8.33, 12.5, and 25 MHz channels sizes
- Diffserv (DSCP) and weighted QoS on a per port basis
- T1/E1 signal level adjustments
- Individual Ethernet Port utilization Statistics
- SNMP OID harmonization with ApexPlus 3.0
- Remote Link status reporting
- Two level access web interface (view/ config)
- Web look and feel changes
- Auto loopback diagnostic
- Add “link down” threshold parameter
- Link Status recording and comparing diagnostic
- Reload/reboot in x seconds
- Linktest added to web
- Web page refresh rate control
- BER calculation improvement
- Eth port loopback diagnostic
- Remove limitation of turning opmode off for a freq change
Add note regarding hardware compatibility by revision
Add detail on 1+1 configuration (LEDs on GE2)
Update Table 3 to add new 7 and 13 GHz TR s
To Next Page
Loading...