Trango Systems, Inc. GigaPlus User Manual Rev 3.1 175
Opmode command is used to enable the transmitter on the ODU.
Opmode settings are not persistent across reboot. See default_opmode
command
freq and speed settings are required to be set to valid value before
opmode can be turned ON.
Passwd <new_password> <confirm_password>
Default: N/A. Default config node passwd is trango
Configuration Storage: Yes
passwd is a system-level command.
<new_password> must be at least 4 characters and no more than 10
characters
<new_password> and <confirm_password> must be identical for the new
password to take effect
Update the current password for entering “config-node”. The new
pasword takes effect only after a reboot command or re-enter the “view-
node” from debug prompt with cli command.
To Next Page
Loading...