Trango Systems TrangoLINK GigaPlus - Uptime

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 200
trap #
IP
enable
Trap 1 manager
0.0.0.0
OFF
Trap 2 manager
0.0.0.0
OFF
Trap 3 manager
0.0.0.0
OFF
Trap 4 manager
0.0.0.0
OFF
Trap 5 manager
0.0.0.0
OFF
Configuration Storage: Yes
trap without any parameter will display the current status for the
snmptrap information
trap is a system-level command.
DESCRIPTION
trap is used to enable and configure traps and the IP address which
they will be sent to
uptime
SYNTAX
Uptime
DEFAULT VALUE
N/A
DESCRIPTION
Uptime is used to display how long the system has been running, since
the last reboot/power cycle.
It shows the current time and uptime.