Trango Systems TrangoLINK GigaPlus - Config Node Command List

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 140
temp
Display IDU and ODU temperature
tftpd
Display tftp server (tftpd) status
threshold
Display threshold status
trap
Display SNMP Trap IP configuration
uptime
Display system uptime
Utype
Display the current unit type (Active or Standby)
version
Display IDU/ODU Software version
voltage
Read voltage values from PIC
Config Node
Users can enter this node by typing in the command “config” from the view node. They
will be prompted for a password and after successful authentication users enters the
config mode. All configuration settings can be changed here.
 All the commands entered without any parameters returns the current
configured values and are similar to “view” node.
 All configuration changes are applied immediately and don’t require any reboot
(except “speed” in which the settings are applied immediately, but it does
require reboot after save).
 All configuration changes have to be saved in order to be persistent across
reboot. A single “save” command will save all configuration changes
 Users can go back to the “view” node by typing in the command exit
Config Node Command List
CLI
Ranges
Default Value
acm
enable <on|off>, mod
Off
alarm
Alarm 1 and 2 <on|off>
Off
alignment_mode
<on|off>
Off
atpc
enable <on|off>, max_power,
step_size
Off
ber
<1-99> seconds
N/A