Trango Systems, Inc. GigaPlus User Manual Rev 3.1 172
mse <duration>: duration range from 1-99 seconds
Default: default duration = 1 second
Configuration Storage: NO
mse without any parameter will display the current mse value for the
received signal.
mse command is used to monitor the Mean Square Error (MSE) of the link
received signal based on the specified duration. CLI prompt will not be
accessible while linktest is running.
oduled
oduled < on| off >
Default: ON
Configuration Storage: YES
oduled without any parameter will display the current status of ODU LED
display
Turn ON/OFF ODU led for display RSSI value. Applies only to SP ODUs
To Next Page
Loading...