Trango Systems TrangoLINK GigaPlus - Config

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 151
DESCRIPTION
This command is only applicable for SP ODUs connected to IDUs that use
hardwareID = 1
cableloss command is used to set the appropriate cable loss ( in dB) for the
3 frequencies based on the length of the IF coaxial cable used to connect
the IDU and ODU.
cableloss info must be sent to the ODU so that it can maintain the output
Tx/Rx power levels accurately. This only applies to SP ODUs. For systems
with HP ODUs no cableloss setting is required. The cable loss
compensation is built in into the HP ODU.
config
SYNTAX
config execute
config export
config import
config remove
config save
config view
Default: N/A
Configuration Storage: No
config is a system-level command.
DESCRIPTION
config execute: The option allows the user to execute a recently imported
config file that was previously saved on a storage media outside the IDU.
The file must have been imported using the config import command
described below