Trango Systems TrangoLINK GigaPlus - Failover

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 159
DESCRIPTION
Display Ethernet port configurations include: enable, status, pause frame,
auto negotiation, duplex, priority, speed and max rate.
User have the options to display one or more port configuration for up to 4
ports for display
failover
SYNTAX
failover
failover <0:off, 1: On with port OFF, 2: On with port ON>
Default: OFF
Configuration Storage: Yes
failover without any parameter will display the current status for
the failover mode
DESCRIPTION
Display and configure the failover mode feature. Failover cable is
required between two IDU for this feature to work properly.
Option OFF: Disable failover mode feature.
Option ON with port OFF: Standby unit disable all Ethernet / TDM
ports.
Option ON with port ON: Standby unit will leave the Ethernet /
TDM port enabled.
When enabled, a KeepAlive message will be exchanged between
the two GigaPlus IDU to determine their utype.
NOTE: This command will set the utype state to default and
perform election period which will affect the radio link. Therefore,
it is not recommended to be executed while the link is running with
traffic.