Trango Systems TrangoLINK GigaPlus - Changing Password

Trango Systems, Inc. GigaPlus User Manual Rev 3.1 56
The Command Line Interfaces keeps a history of commands used, pressing the up arrow
will display previous commands used. The CLI can supports auto-complete of a
command being typed by pressing <tab> key. If a command is partially typed followed
immediately by a “?” it will display all related commands.
Example:
(CLI-config)# ? (The ? will not be display)
targetrssi Set target RSSI level for ATPC
tdm Display TDM configuration
telnetd Enable/Disable telnetd
temp Display IDU and ODU temperature
tftpd Enable/Disable tftpd
threshold Set the threshold for the radio parameters
trap Display snmp trap management information
(CLI-config)#
!
TYPE “?” FOR A LISTING OF ALL CLI COMMANDS.
Changing Password
The debug and view node share the same password. The config node has a separate
password. The view and debug mode password is changed in the debug mode. The
config node password is changed in the config node. Use the CLI command passwrd to
change the password. The example below demonstrates changing the password for the
config node to “control”
Syntax: passwrd <newpassword> <newpassword>
Example:
(CLI-config)# passwrd control control (The password must be entered twice)
If the command is properly executed, the system will return a “SUCCESS” and return to
the CLI-config prompt.
If the password is lost and the unit is locked, the pushbutton on the access panel can be
used to reset the password and default IP back to the factory settings