loglevel is used to set the appropriate logging for the system.
This command is used to set required log levels for system logging. The log
level needs to be set for each activity to be monitored. Once the loglevels
are set, the logs can be monitored through the “syslog” command
Activates one of the loopback modes for test purposes. Must be turned off
by a command. The CLI is still active while the mode is on to allow
monitoring of various parameters.
loopback off is the normal link operational mode.
loopback dig loops data back at the modem before modulation onto the
intermediate frequency (IF)
loopback IF loops the modulated signal at 350 MHz back to the RX IF
frequency of 140 MHz and demodulates the signal in the modem.
Loopback_auto runs digital and IF loopbacks automatically for a specified
number of iterations, then resets the link back to normal mode. This is
very useful for remote radios which will break the link during the loopback
and then return to normal mode to be managed again. This command will
automaticall turn the Ethernet ports off as well and prevent a loop from
occurring on the network.
To Next Page
Loading...